When directed by our customer support team, a reader module replacement may be required. Please carefully review the below steps before completing the swap and reach out if you have any questions.
- Phillips Head Screw driver is only tool needed
1) Remove battery from T1 Tomahawk
- Slide open back cover completely and remove battery for duration of process.
2) Flip T1 upside down and remove two screws 2 Phillips Head Screws
- PH1 screwdriver should be used to turn screws counter clockwise
3) Slide Reader Module out using tab at top
- Use fingernail to pull grey tab at top of assemble and gently slide out.
- Do not use tool to pry out.
4) Slide out front latch and back cover
- Pinching tape measure blade can assist with process of removing once front latch and back cover removed
5) Install New Reader Module
- Carefully ensure all components are assembled correctly
- Ensure use all new components (dont mix and match old and new components)
6) Reinstall Reader Module into T1 Tomahawk
- Reinstall two Phillips head screws. Do not over tighten
7) Turn on T1 to ensure T1 was reassembled correctly.
8) Hold the "Units" button for 10 seconds to enter the main menu. Perform Blade Setup to complete replacement.
Comments
Where do I order a reader module?
Hi James, please reach out to us at contact@reekon.tools if you are having issues with your reader module
Please sign in to leave a comment.