Clamping to Fence - M1 Caliber

The M1 Caliber's unique clamping mechanism has been designed to work directly with a wide range of saw fences. The M1 can clamp directly to any flat surface less than 7mm (9/32") thick. The clamping feet have extended arms to allow the M1 to clear any ribs on the rear of the fence, allowing you to clamp anywhere along the fence. 

If you would like to see if your specific saw model is listed in our table (to check for direct or Adapter Plate compatibility) check out our helpful Saw Fence Compatibility Chart.

 

SideClamping.gif

M1_Claiber_Clamping.gif

Clamping Requirements Diagram 

Screen_Shot_2021-02-18_at_4.21.36_PM.png

Screen_Shot_2021-02-18_at_4.21.46_PM.png

Clamping Tips

  • Clamping feet should be clear of any obstructions or ribs
  • Clamping feet pads should have and maintain full contact on flat surface 
  • M1 Body is rigidly coupled to the Saw Fence
  • When clamping ensure that fingers are not triggering the lower handle latch to release the clamp

Clamping Examples 

Screen_Shot_2021-04-08_at_12.42.16_PM.pngScreen_Shot_2021-04-08_at_12.43.04_PM.png

CRR_5689.jpgCRR_5199.jpg

 

 

 

 

 

Was this article helpful?
3 out of 4 found this helpful

Comments

0 comments

Please sign in to leave a comment.