[T1R] Reader Module Replacement

When directed by our customer support team, a reader module replacement may be required. Please carefully review the steps below before completing the swap, and reach out if you have any questions.

Removing the Reader Module

1. Power off the T1R by navigating to the main menu.
2. Use a PH1 Phillips screwdriver to remove the two screws on the front sides of the device.
3. Hold both sides of the reader module and slide it out through the mouth of the T1R.
4. Remove the auto-lock latch from the assembly by sliding it forward.
5. Carefully slide the blade around the reader module connector to disconnect it.

Installing the New Reader Module

1. Slide the blade through the side of the new reader module.
2. Confirm all components, including the auto-lock latch, are correctly assembled.
3. Reinsert the reader module into the T1R.
4. Reinstall the two Phillips head screws (do not over tighten).
5. Power on the device and confirm the module works properly.
6. Navigate to the main menu to perform blade setup and recalibrate the T1R.