Derrick Rock
Comments
-
Hey Mark, shoot us an email at contact@reekon.tools with your device serial name and revision and we would be happy to assist!
-
HI Richard, with the newer M1s, you can just pull the arm down to release as they have an upgraded mechanism in them!
-
Hey John, you can find more details on cutting angles here: https://support.reekon.tools/hc/en-us/articles/360057191331-Getting-Started-with-Angled-Cuts-M1-Caliber-
-
hey Tony, please send us an email at contact@reekon.tools and we would be happy to help!
-
Hey Zachary, the device needs to be turned off to enter calibration mode. From the behavior you are describing, it sounds like it is being done with the M1 on. To enter calibration mode, starting...
-
Hey Trent, appreciate the feedback and some great suggestions! The ball spring plunger in the arm is a new feature of the arm for newer M1 units (we have updated the article to reflect this).
-
Hello Theodore, there is no need to recalibrate if the material type not changing. When cutting the same type of material, simply begin your measurement as you always would (hit the zero button wh...
-
Hi Darwin, does it turn on at all normally? If so, then try very quickly clicking the power button while holding the other two. If still not, please send a video to us at contact@reekon.tools and ...
-
Hi Darwin, are you holding the power button or just clicking it once? The symptoms you describe usually happen when you hold all three buttons vs just the left two and the power button once.
-
Hello Jose, thanks for reaching out. It sounds like there might be a loose magnet in the wheel. Please send us an email at contact@reekon.tools and wed be happy to help get everything up and runn...