Derrick Rock
Articles
-
[T1] Layout Guide
(Available now - upgrade to firmware version 0.5.13 or newer to use this features) The Layout guide is a Quick Action Feature that, when enabled, allows the T1 Tomahawk to turn on its laser as it a...
-
[T1] Blade Setup Troubleshooting
Values Too Far Out of Range If you see the below message, it means that the alignment of each step was not completed correctly.\ Please repeat the processing ensure the following: Move slowly fr...
-
[ROCK] Where can I request new features for the App?
We welcome new features suggestions and we are actively working on a variety of new ones to continue to make the ROCK Jobsite App the best software for the jobsite. If there are specific features ...
-
[ROCK] APIs
The ROCK Jobsite App has several future APIs planned to continue to increase the usefulness and functionality of the app and allow direct integrations between the ROCK App and other existing platfo...
-
[ROCK] REEKON Forum for App
The REEKON Forum is the best way to discuss with the tens of thousands of fellow users about applications, ideas, use case, and more! Sign up and make your first post here.
-
[ROCK] Unit Conversions
Conversions allow for intuitive converting between a variety of units. Conversions are considered objects as they cover a wide range of nonlinear measurement units. To Create a new Conversion: Se...
-
[ROCK] Notes
Notes are an easy way to add jobsite specific notes, punch list items, issues, or anything text based. On the Objects tab in selected Area, select the "+" icon in the bottom middle corner and sele...
-
[ROCK] Measurement Detail Page
While the Measurement Grid shows a consolidated view of measurements, they can be selected to see additional attributes and details of a given measurement. To enter the measurement detail page, s...
-
[ROCK] Measurements and Files
All data within the ROCK App are located in Areas. Within areas, data is separated into two tabs, Measurements and Files. You can toggle between the two tabs by selecting one or the other. Measurem...
-
[M1] Is the blade offset saved when I power off the M1?
Yes, once a blade offset is saved to the M1, it is automatically stored in the tool until a factory reset or new calibration. The saved blade offset should appear on the screen each time the zero b...