Derrick Rock

Total activity 553
Last activity September 29, 2026 15:11
Member since February 16, 2021 19:58

Following 0 users
Followed by 2 users
Votes 9
Subscriptions 192

Comments

Recent activity by Derrick Rock

Hi Erik, to do this, first enter "Center" mode to find the center of a measurement. Hit the save button to save it to the epaper display. Next, leave center mode, scroll up to highlight the cent...
- View comment
- Created July 08, 2024 13:34
- 0 votes
Hi Dustin, it sounds like there might be an encoder issue, please send us an email at contact@reekon.tools and we can take a closer look!
- View comment
- Created June 22, 2024 19:12
- 0 votes
contact@reekon.tools
- View comment
- Created June 21, 2024 11:34
- 0 votes
Hey Adam, our apologies! Please send us an email with your name, address, and device serial name and we will have one sent out!
- View comment
- Created June 21, 2024 00:16
- 1 vote
Hello Marcel, hope you are doing well. The blade compensation and calibration are completely independent activities. Calibration should be from left side of saw blade to left side of the saw blad...
- View comment
- Created June 16, 2024 17:56
- 0 votes
Hi Steve, please send us an email at contact@reekon.tools and we would be happy to check!
- View comment
- Created May 21, 2024 01:13
- 0 votes
Hi Kris, this happens automatically when you connect to the ROCK Jobsite App
- View comment
- Created May 01, 2024 15:25
- 0 votes
Hello, please send us an email at contact@reekon.tools as the ROCK App works on a most modern phones
- View comment
- Created April 26, 2024 18:52
- 0 votes
Hi Larry, the wheel is needed for the calibration when you slide the material
- View comment
- Created April 24, 2024 14:36
- 0 votes
Hi Larry, resets are not needed to perform calibration. Are you sure you are entering calibration mode with the M1 turned off (wont work and enter the menu if it is on)
- View comment
- Created April 24, 2024 14:33
- 0 votes