Derrick Rock
Comments
-
Hi Jim, thanks for reaching out. While setting the blade width is not needed for calibration, it is needed to get accurate cuts. Setting the blade width and calibrating the M1 are two completely ...
-
Hello Jerbou71, please reach out to us at contact@reekon.tools and we can take a look
-
Hi Dain, please send us an email at contact@reekon.tools and we would be happy to help!
-
Hi Blake, washers will work fine and the squaring is controlled by the integrated fence (the back section and bottom) so as long as it i pushed up against both it will be square assuming the fence ...
-
Hi Regis, please send us an email at contact@reekon.tools with the above information and screenshots and we would be happy to take a look!
-
Hi Régis, that is normal as the epaper screen doesnt need power to stay on (one of its unique features) so this behavior is normal!
-
HI Morad, please send us an email at contact@reekon.tools and we would be happy to help
-
Hello Kevin, unfortunately we do not have them available at this time
-
Hey Butch, not at this time but we are always open for future product suggestions! You can leave a post on our forum at https://forum.reekon.tools as well for consideration in our upcoming roadmap.
-
Hi Marco, yes both are possible. Please make a post on our forums here and someone will outline the process - https://forum.reekon.tools/